Description:
Pines #2 CNC Updated In 2007
All new Adaptive programmable controls/touch screen interface, Nice low hour Machine , Upgraded C axis proportional valve for more accurate bending, Model ENC- 075, Left hand bend, 200 Deg max bend, 3" Hole through plane of bend, 6' Travel on plane of bend. Steel tubing, Y.P. to 40,000 PSI, 3" x .109"; Stainless steel, Y.P. to 60,000 PSI, 3"x.065" ; Non-ferrous tubing, Y.P. to 25,000 PSI, 3" x .188" ; Steel pipe, Schedule 80 2" ; Pump motor 20 horsepower; Standard bend radius to centerline 12"; Standard max. tube length over mandrel 120"; Standard carriage travel 72", Machine has not been used since update, Can be seen under power on are floor
CALL Rick Canniff 612 281-3736
Specifications:
1 Refurbished Pines no. 2 tube bender-CNC
Model ENC-075 S/N 13900-82063
--------------------------------------------------
General Specifications:
Up-Dated 07 New Adaptive Controls
Touch screen interface system
Controls: Main Cabinet
Enable/Pump start/Cycle start/Cycle Hold& Edit-Lockout/Jog+/jog-/Emerg.Stop
Stand Control: Enable/Fwd/Load/Emerg. Stop&
Clamp/collet close/cycle stop
Auto. Lube System & Adj. -Air System 90 PSI required
Left Hand bend, 200 deg. max. bend, 0-200 adj. stops
Capacity:
3" hole through plane of bend
6' Travel on plane of bend
Steel tubing, Y.P. to 40,000 PSI 3" X .109"
Stainless Steel Y.P. to 60,000 PSI 3" X .065"
Non-ferrous tubing, Y.P. to 25,000 PSI 3" X .188"
Steel Pipe, Schedule 80.....2"
Pump Motor 20 HP. 440/3 Ph.
Standard bend radius to centerline.....12"
Standard Max. tube Length over mandrel 120"
Standard carriage Travel....72"
Comes with operation Manual, blue prints and warranty.
Sincerely,
Rick Canniff
612 281-3736
