IPC Black-Box/WB-05 DCC Controller for RETROFIT of Measuring Machines
ADVANTAGES :
-for customer optimized retrofit of a 3D-Coordinate Measuring Machines (CMM), no matter if manual driven or DCC.
-Reliability and flexibility by well-tried and world-wide experienced software
-Spares the cost for new constructions and facilities (CMM, measuring room, environment and temperature control, a.s.o.)
3D-Coordinate Measuring Machines (CMM) represent a high investment. This is the reason why they should be in use over many years. Mostly the CMM’s are moving on air bearing, this is why they have practically no wear, opposite to the other machine tools. While in most cases the mechanics of a CMM is as good as new, especially if the CMM was serviced normally, the DCC electronics, along with the hard- and software of the evaluation system became over few years obsolete, due to the rapid pace of the technical development in electronics and computer area.
We offer with the Black-Box/WB-05 DCC Controller an optimal, economical solution of your measuring problems, shaped on your needs.
The retrofit of your existing CMM’s is a cost-effective alternative to buying a new CMM.
The efficiency of the measurements is the same as for a new machine
